Pneumatic-hydraulic jack 50/25t (M80390)

The pneumatic hydraulic lift belongs to the group of point lifts, whose task is to lift a vehicle along the vertical axis. The lift is powered by compressed air, which causes the hydraulic pump to rotate, creating pressure in the hydraulic cylinder section. An increase in pressure causes the telescopic part of the drive to extend upwards. A drop in pressure causes it to sink and flow downwards. Important elements of the design also include the length of the jack, which affects the convenience of working when lifting vehicles with difficult access to support points. Lifts of this type are equipped with wheels, allowing them to move on the ground. There are also versions designed for portable work, which are much lighter and smaller in size, making them easy to transport in a service vehicle.

Thanks to the installed grease nipple, the friction force of the mating surfaces is reduced, which decreases their wear and protects against corrosion. Oil often also plays the role of a coolant.

These lifts are used in the operation of trucks, buses, agricultural machinery, as well as armored military vehicles.

The device is equipped with two additional tips that increase the lifting height. Road wheels facilitate transportation.

The jack handle can be adjusted to three different positions for greater working convenience.

Technical data:

• Capacity: 25/50 t
• Minimum height: 195 mm
• Maximum height: 370 mm
• Recommended hydraulic oil: L-HL 46
• Working pressure: 6-8 bar