Induction heater 1.5 kW (DIH15KW)

Used in the automotive, railway, and shipbuilding industries, metalworking, and maintenance
Used in forks that require speed and flexibility and are at risk of damage from open flames around hot parts (insulation, rubber couplings, wiring, etc.)
Facilitates the removal of rusty bolts and old parts, heating exhaust pipes, bolts, nuts, bearings, tools before hardening, gluing, soldering, and is excellent for defrosting
Voltage 220V, 50 Hz
Power cord 1.5 m
Spiral heating cord 0.8 m
Power 1.5 kW / 3.2 kVA
Consumption 8 A
Do not exceed the operating cycle of DIH-1.5 kW – 2 minutes heating (on) and 2 minutes cooling (off)
Safety code IP20
Operating frequency 25 - 65 kHz, automatic adjustment
Class I protection
Cooling with a fan
PF (power factor) 0.99 (PFC)
Overheating, overload, and short circuit protection of the coil
Flame and spark-free heating
Dimensions 210 x 140 x 90 mm
Weight 4.6 kg

Warranty 12 months

Repeaters – only the following extensions can be used if necessary:
up to 5 m with a diameter of 2.5 mm2
up to 15 m with a diameter of 4 mm2
When using the device with an alternative power source - for example, when using a mobile generator, it is necessary to use a quality device
Use a generator with a power of at least 3-4 kW or a DC/AC converter with a power of 2-3 kW and only with a sine wave – do not use an inverter with a square or quasi-sine wave
Failure to comply with the above requirements may damage the device and the warranty will be void