Grass trimmer 1000W DED8716 (DED8716)

Grass trimmer Garden DEDRA DED8716

This device is designed for mowing and taking care of the lawn.

The grass trimmer is powered by a four-stroke 0.9kW combustion engine. The use of a four-stroke engine has resulted in a high level of operational comfort, reduced noise levels compared to conventional two-stroke engines, as well as eliminated the need to prepare the fuel mix, which makes the trimmer easy to handle. In addition, the four-stroke engine is much easier to start, even with a cool engine.

A monofilament with a diameter of 2 - 2.4 mm can be used for low and fine grass, and a sharp cutting blade for high, dry grass. The average cutting height is 430mm for the monofilament and 255mm for the blade. The machine has a rotational speed of 9,500rpm. The capacity of the fuel tank is 650 ml. For greater durability and quality, the trimmer is equipped with a one-piece drive shaft. Most low-cost designs havea two-piece shaft, which loosens up easily and results in quick wearing down of the device.

The trimmer has a handle in the form of a handlebar with a gear lever on the right side.

Features of the grass trimmer DEDRA DED8716:

• Four-stroke, air-cooled, single-cylinder engine
• OHC engine type - overhead valve upper timing gear engine
  
• Easy starting even with a cool engine
• No fuel mixer - simple operation
• Environmentally friendly - lessexhaust emissions
• Economical fuel consumption
• Silent operation
• Large cutting width: 430 mm monofilament, 255 mm cutting disc
• Two ways of trimming: with monofilament or blade
• One-piece drive shaft
• Additional suspenders included
• Convenient steering wheel
• Tap&Go - system for easy line winding

Technical data of the grass trimmer DEDRA DED8716:

• Engine type: combustion, four-stroke
• Engine capacity 35,8cm3
• Engine power: 0.9kW/1,2hp
• Cutting width with a disc: 255 mm
• Cutting width with a monofilament: 430 mm
• Rotational speed: 9500 rpm
• Monofilament diameter: 2-2.4 mm
• Fuel: PB95

Included:

• Extension arm (1 pc)
• Motor with the equipment (1 pc)
• Steering handle (1 pc)
• Cutting element shield (1 pc)
• Head with a monofilament (1 pc)
• Cutting disc (1 pc)
  
• Elements and montage accessories (1 set)

Specifications